Drilling the keyswitch hole on the right side of the Freikometer. Use a 1.25" Forstner bit and cut to a depth of 3mm. Make sure the depth is evenenlarge 58kbprint 2562kb
The first step completed: 3mm x 1.25" holeenlarge 62kbprint 2677kb
Mark the top and bottom of the keyswitch hole with a 1" Forstner bit. Just graze the surfaceenlarge 62kbprint 2673kb
Note the subtle 1" from center markings which are then emphasized with a Sharpieenlarge 54kbprint 2567kb
Drill 5/8" hole all the way throughenlarge 63kbprint 2613kb
Dremmel out the top an bottom with the "fast cutter" bit. This is relatively easy, but take your time. enlarge 54kbprint 2456kb
The finished hole with keyswitch installedenlarge 73kbprint 2830kb
The hole finished without keyswitch, view from topenlarge 47kbprint 2352kb
Another view of the finished holeenlarge 66kbprint 2714kb
Drill a hole for the antenna using a #6 bitenlarge 56kbprint 2423kb
Drilling the keyswitch hole on the right side of the Freikometer. Use a 1.25" Forstner bit and cut to a depth of 3mm. Make sure the depth is even
The first step completed: 3mm x 1.25" hole
Mark the top and bottom of the keyswitch hole with a 1" Forstner bit. Just graze the surface
Note the subtle 1" from center markings which are then emphasized with a Sharpie
Drill 5/8" hole all the way through
Dremmel out the top an bottom with the "fast cutter" bit. This is relatively easy, but take your time. 
The finished hole with keyswitch installed
The hole finished without keyswitch, view from top
Another view of the finished hole
Drill a hole for the antenna using a #6 bit
