Boltage - Blog Detail

Blog Detail

Pictures from 09/14/2008

posted on (last edited by Rob Nagler on )

Freikometer version 5 (FM v5) connector for LED, speakers, and power. Inside view of 5 pin DIN female before casing enlarge 78kb print 3130kb	5 pin DIN female after casing enlarge 56kb print 2670kb	5 pin DIN male after casing enlarge 65kb print 2752kb
5 pin DIN female after hood is put on enlarge 56kb print 2791kb	Inside of connector wall on chassis. Wiring is run under aux boards enlarge 98kb print 4128kb	Inside of connector side of chassis (same as previous with different lighting)enlarge 98kb print 3556kb
Front of motherboard: LED and powerbutton writes on bottom of picture and 12v wires for amp is at top enlarge 124kb print 4246kb	Close up of connectors and chassis power button enlarge 82kb print 2995kb	Connectors seen from outside of chassis enlarge 40kb print 2593kb
Power wiring and USB added enlarge 98kb print 3874kb	Completed wiring of chassis. Note cable tie to hold power connector to RFID MMCX connector enlarge 136kb print 4758kb	Rubber feet on bottom and rubber bumpers on sides to reduce jiggle during shipping and high winds enlarge 58kb print 3037kb
Speaker wires (4") with RS-232 male pins as ersatz speaker pins attached to 5 pin DIN female enlarge 62kb print 2868kb	LED and wire on 5 pin DIN female. Note anode (long lead) is attached to red, and only one side has heat shrink enlarge 63kb print 2935kb	Keyswitch wiring to the 5 pin DIN female. The LED is also seen completely wrapped in heatshrink. The keyswitch is "on" when the left and right are connected. Left and right correspond to the flat sides of the keyswitch enlarge 52kb print 2429kb
Inside view of FM with battery, solar controller, and chassis enlarge 82kb print 2793kb